VP Networks SuperAP 570n Manual de usuario descargar pdf (Pagina 14)

5.2.4. DHCP Server

DHCP is enabled by default. Configure according to your design under Networks –

Server – DHCP Server.

5.2.5. VPN Static IPs

You must provide additional routable static IP addresses for customers to establish VPN

connections. You or the hotel must purchase additional static IP addresses from the

ISP. Enable this feature under Advanced – VPN Static IPs. Please see the product

manual for full details on configuring this feature. ValuePoint does not have information

on how many static IP addresses are required for customer use at a particular hotel. 10

is currently the maximum in the Controller 3000, 200 for the Controller 3500.

5.2.6. Remote access to network hardware

After installation the Controller can be accessed by directing your browser to the Static

IP address. You can also access the web interfaces of other hardware in the system by

adding individual devices to the AP Monitor. You can configure this under

Management – Access Point Monitor. During operation you can monitor and access

APs under Status – APs.

5.2.7. PMS Interface

HSIA access that is billed to the room must support the appropriate PMS interface for the

hotel in question. This could be one of Micros Fidelio, Courtyard PMS, Richie PMS,

MHRS Full Service PMS, and Pegasus Guestview. The Controller 3000 does not

support PMS, so you will need to use the Controller 3500.

5.2.8. Configuration Backup

The Controller Configuration can be backed and restored under System Tools –

Maintenance – Configuration.

5.2.9. SSL encrypted Authentication

Authentication must by protected by HTTPS privacy using SSL. The can be configured

under Networks – Server – Web Server – HTTPS. Note that this will SSL encrypt the

Controller GUI as well, which will cause management pages to load more slowly due to

the encryption.

5.2.10. Client Isolation

Marriot requires that guests not be able to ping or access each others computer’s on the

network. This can be done in two ways:

1. Controller Subscriber VLAN: Enable Subscriber VLAN in the Controller under

Networks – System – Subscriber VLAN. In this configuration the Controller will block

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Sin comentarios

VP Networks SuperAP 570n Manual de usuario Pagina 14